Standard for cutting disc
Nowadays, there are many kinds of cutting discs on the market, which can meet the requirements of different items cutting, so it will also improve the work efficiency. But when in use, it must match the cutting objects, otherwise it will cause great safety risks, and there will be great damage to the equipment, and the final cutting effect can not meet the production requirements. Different cutting needs must use different materials of cutting pieces, if you want to cut steel bar or steel pipe, you can use resin cutting pieces.
This material is the hard steel material for cutting, but in the work, due to the high speed operation will occur a certain shake, so when holding the handle to have a good strength to grasp the balance, so that there will be no greater movement, thus affecting the safety, for the quality of cutting will not meet the requirements, so the appropriate strength to hold the handle, Avoid large vibration, also has a high efficiency improvement. When working with resin cutting pieces, it is not necessary to use a particularly large force for extrusion cutting.
We can use a little force properly, otherwise the wear and tear of this kind of cutting piece will cause great harm, so it will form unnecessary waste of materials, and too much force will produce debris, which will cause bruises to the human body. And before use, we must see whether there is a crack or damage on the cutting piece. This type of cutting piece should be discarded directly and can not be continued to be used. Another type of cutting sheet is the polishing sheet, which can sand the uneven material on the concrete.
In the use of this kind of cutting pieces often have a huge dust generation, we must carry a mask, to avoid breathing harm to the human body, at the same time, this type of polishing plate we need to pay attention to is that they must be reinforced before use, in order not to let some loose when grinding caused by equipment damage and personnel injury. Therefore, no matter what type of cutting pieces, we should carefully observe the damage of the material before use.
